免费一级a毛片在线播放'视频正片,欧洲破处AV,妖精囯产A片,九九热视频这里只有精品,国产美女在线一区二区三区,国产18在线播放

Luster

Glossy

Theoretical spreading rate

120g/m2, 10.5-11.4m2/L (calculated by 50μm dry film, excluding loss)

Specific gravity:

About 1.26-1.37

Drying time

23±2℃：surface dry: 2h, hard dry: 24h

Entirely cured

23±2℃：7d

Flash point

27℃

Storage period

12 months for Component A, 6 months for Component B

Construction Instruction

Mixing ratio

Component A: Component B=3:1

Maturing time

23±2℃：20min

Service life

23±2℃：8h

Construction method

High pressure siphon spray, manual brushing, roller spray.

Diluent

Special diluents for X-9 modified epoxy finish.

The largest amount of dilution

≤5%

Spray orifice

0.46~0.53mm

Spray pressure

250kg/cm2 (spraying information are for reference only and can be adjusted when in practice).

Tool washing

Special diluents for X-9 epoxy finish

Film coating thickness

Wet film: 85μm, dry film: 50μm

Coating interval

Surface treatment

If the preceding paint has been contaminated, take proper measurements to remove grease, dust, and also diluent for the preceding paint can be used to scrub.

Construction condition

Temperature is in -10℃ - 35℃, relative humidity shall be less than or equal to 85%, surface temperature of the object to be painted shall greater than dew point above 3℃, construction shall be forbidden under the condition of rain, fog , snow and larger dust.

Prior primer

Zinc-rich epoxy primer, micaceous iron epoxy antirust paint, iron red epoxy antirust paint and so on.

Maintenance period

23±2℃：more than 7d.

Packing Specification

Container of 20 liters can load Component A of 18kg, container of 5 liters can load Component B of 2kg.

Remarks

Film thickness can be adjusted according to demands, however, that can correspondingly change spreading rate and affect drying time.

Considerations

*If coating time of the preceding paint is too long, when coating the sequent paint, roughen the surface with waterproof abrasive paper, paint the coating after clearing away the dust and dirt on the surface to assure the adhesion between layers;

* Tools for construction shall be clean and dry, the coating shall not be mixed with water or other impurities, prepare the coating at the time of use, and the coating shall be used up in 8h.

* Before entirely cured and dry, take protection measurements for the film to avoid the washing and trample from rains or other liquid.

* Coatings shall be stored in a dry and ventilated place, kept away from heat source, and avoid direct sunshine and isolated from fire.

Safety guide

Please pay attention to the security issues on packaging. In addition, relevant Safety guide codes of nation or specified by the local government shall be followed. Avoid inhaling solvent vapors and spray mist for long term, skin and eye may not contact with the product.

Forced ventilation shall be provided when applying the paint in confined spaces or stagnant air, although in good ventilation, protection tools shall be worn.

Annotation

＊Above-said thickness of dry film and wet film refers to the index while implementing the high-pressure air-free spray;

＊Relevant data in this instruction is obtained from laboratory, the actual product may be slightly different from it;

＊If above data is changed, the data is based on the latest instruction, without prior notification.